Products
Bluelab ph & conductivity probe care
Bluelab EC and PH Tester Cleaning and Maintenance Kit
Accurate readings simplify crop management and ensure crop improvement . Cleaning and properly storing the probe ensures that you get the most accurate readings possible and increases its life. The surface of the probe is where the instrument reads a solution or soil measurement . If the probe body is dirty , readings may be inaccurate.
Tip: If the EC tester reads a lower conductivity than the actual one, the probe needs cleaning. pH probes specifically, must be kept moist at all times for optimal performance and life.
The set contains:
- calibration solution pH 4.0 20ml x 2 pcs
- calibration solution pH 7.0 20ml x 2 pcs
- calibration solution pH 2.77 20ml x 2 pcs
- solution for storing pH tester KCL 20ml x 2 pcs
- solution for cleaning the EU probe 30 ml x 1 pc
- pH probe cleaning solution 30ml x 1 pc
- cleaning equipment
BlueLab Conductivity probe care
BlueLab kit for maintenance and cleaning of EC Tester
Kit Contents:
- Probe care instructions
- Two single-use sachets of 20 ml Bluelab 2.77 EC Conductivity Standard Solution
- One plastic cup
- Bluelab Conductivity Probe Cleaner
- Conductivity probe cleaning tool
- Build-up cleaning brush
Bluelab Conductivity Probes (EC/PPM)
Cleaning and care:
To get the longest life and most accurate measurements from your conductivity products, be sure to clean your pen every month.
Quick Tips for Conductivity Probe Care:
Do not touch the probe sensors with your fingers. This can contaminate the probe with oils.
Do not immerse in oils, proteins or suspended solids. This will leave a coating on the probe tip that will affect the measurements.
How to clean the conductivity probe:
- Remove the cap.
- Add a few drops of Bluelab Conductivity Probe Cleaner to the face of the probe.
- Use the cleaning tool to clean the face of the probe, removing debris and build-up.
- Rinse the face of the probe with clean running tap water to remove traces of detergent.
- Replace the cap, being careful not to touch the face of the probe
